CentOS 6 or 7

Follow the general directions, 2.3.2, above when opening the TAR archive.

• CentOS 6 - The tested build was done on Kernel 2.6.32-696.1.1elb.x86-64, 64 bit system. From the top directory one runs configure with appropriate options. Choose one of the following (note: options start with a double dash ``- -`` before the ''with'' and a single dash after the ``with``:

  configure -with-plplot-old -with-plplotlib
  (this assumes plplot 5.9.9-5 package with old function names)

  configure
  (no options will use Gnuplot instead of Plplot)

  NOTES ON DEPENDENCIES
  The following RPM packages were installed for this test.

  plplot-5.9.7-3.el6.1.x86_64

  octave-3.4.3-2.el6.x86_64

  gsl-1.13-1.el6.x86_64

  gsl-devel-1.13-1.el6.x86_64

  lapack-3.2.1-5.el6.x86_64

  lapack-devel-3.2.1-5.el6.x86_64

  blas-3.2.1-5.el6.x86_64

  blas-devel-3.2.1-5.el6.x86_64

  gnuplot-4.2.6-2.el6.x86_64

• CentOS 7 - The tested build was done on Kernel 3.10.0-514.16.1.el7.x86-64, 64 bit system. From the top directory one runs configure with appropriate options. Choose one of the following (note: options start with a double dash ``- -`` before the ''with'' and a single dash after the ``with``:

  configure -with-plplotlib
  (this assumes plplot-5.10.0-9 package with new function names)

  configure
  (no options will use Gnuplot instead of Plplot)

  NOTES ON DEPENDENCIES
  The following RPM packages were installed for this test.

  plplot-5.10.0-9.el7.x86_64

  gsl-1.15-13.el7.x86_64

  gsl-devel-1.15-13.el7.x86_64

  lapack-3.4.2-5.el7.x86_64

  lapack-devel-3.4.2-5.el7.x86_64

  blas-3.4.2-5.el7.x86_64

  blas-devel-3.4.2-5.el7.x86_64

  gnuplot-4.6.2-3.el7.x86_64