Follow the general directions, 2.3.2, above when opening the
TAR archive.
- The tested build was done on Kernel 2.6.32-696.el6.x86_64, 64
bit system. From the top directory one runs configure with appropriate options.
Choose one of the following (note: options start with a double dash ``- -``
before the ''with'' and a single dash after the ``with``:
- configure -with-plplotlib
PKG_CONFIG_PATH=/usr/lib64/lib/pkgconfig
ENTERPRISE TIPS
The plplot RPM is too old to support Fortran F90, so built a newer one as
follows.
- untar plplot-5.10.0 in /usr/local/src
- cmake as described 2.3.6 except for install directories.
- plplot installed in /usr/lib64/lib
/usr/lib64/include
/usr/lib64/share etc....
pm
2018-04-08