Follow the general directions, 2.3.2, above when opening the
TAR archive.
- The tested build was done on Kernel 4.4.0-78-generic, 64 bit
system. From the top directory one runs configure with appropriate options.
Choose one of the following (note: options start with a double dash ``- -``
before the ''with'' and a single dash after the ``with``:
- configure -with-gnuplot5 -with-plplotlib
(this assumes plplot-5.10.0 or newer packages with new function names and
gnuplot-5.x.x)
- configure -with-gnuplot5
(will use Gnuplot instead of Plplot)
- configure -with-gnuplot5 -enable-all-static
(this will use Gnuplot instead of Plplot and build static binaries.
pm
2018-04-08